Stroy-concrete plant for the company “USG Stroy-System of Rus'” (now the unit of KNAUF) were producedThe capacity of weight dosage, the powder transmission system from this container to pneumatic transport and the powder distribution module in the pneumatic transport itself.More
The dispenser was made according to the individual drawing and equipped with both tensodists and the information remote control module to the information remote control. From the dispenser, the powder is transmitted by the rotary feeder to the distribution module and then to pneumatic transport.
List of delivered products:
- Weight hopper 1.5 cubic meters. Complete with 3 tensodes and a weight display panel and transmission of the Tenzo-M signal, a flange for the FNC1J02 filter, a pipe with a diameter of 273mm, a length of 1 meter.
- The lower node of the distribution of material for pneumatic transport.
- A screw feeder for difficult working conditions without intermediate supports, a diameter of 273 mm, length 5000 mm, round input with a diameter of 273 mm and a height of 400 mm without a flange, a round output without a flange with a diameter of 273 mm and a height of 400 mm, an angle of inclination 35 degrees, a gear ratio 1/30, 48 rpm – coupling, engine power 7.5 kW, the position of the engine at the output, the approximate estimated performance of 12 m3/h.
- Rotor feeder, material – cast iron, 20 liters per turnover, 30 rpm. The calculation performance with a filling of 80% is 19 m3/h.
- The shutter is throttle, single -ofland, diameter – 250 mm.
