The piercing valve VM is produced by WAM and is designed to block the lines of feeding materials in pneumatic vehicles dosing equipment and. P.
- Download price list >> (Typical valves are in stock in stock! Shipment for 1 day from Moscow throughout Russia)
The main difference between a piercing valve and ordinary cranes is that in an open state the internal cross section of the valve is equal to the cross section of the pipe and therefore the material can be transmitted without loss of performance.
An important feature is the closing speed, this occurs in a fraction of a second, because The process of extending is supplied with air.
Thanks to these characteristics, the Subsidious VM valves are widely used to block the flows of materials in pneumatic systems, on the supply of materials in the silo, in dosing, etc.
Technical characteristics and competitive advantages
- Small size
- Simple replacement of the wear -worn parts
- The transmitted material is in contact only with the inside
- Work pressure up to 3.5 atm.
- Swelling pressure up to 6.0 atm.
- Differential pressure up to 2.5 atm.
Options of puffy valves
The main characteristic is the inner section. Perhaps production:
- 13mm
- 20 mm
- 25 mm
- 32 mm
- 40 mm
- 50 mm
- 65 mm
- 80 mm
- 100 mm
- 125 mm
- 150 mm
- 200 mm
Options
- Explosion -protective performance on ATEC 22
- Selection of couplings depending on the material in the pneumatic system
- Different connecting flanges
Prices for typical piercing valves canView in the price list >>
Download Technical description of the peremnial valve >>
Photos of application
